The Curvamizer Genesis Style ReBuildable Atomizer Tank!

[Drewsworld]

Introducing the NHaler Curvamizer Genesis Style Rebuildable Atomizer tank!

The Curvamizer


After grueling research and development NHaler is proud to release our newest RBA device. This particular atomizer was designed to match the Curve APV sold by NHaler, however, it will work on most 510 devices that are capable of holding High Drain IMR batteries.

There is a video below on how to build one of these but you may see that many are experimenting and building them differently with many styles of wicks and coil combinations.

This Genny Style tank is for Advanced Users that are familiar with Rebuildable Atomizer safety and should not be purchased by the beginner. These devices require the user to make there own coils and wicks.

Hand Crafted in the USA, The Curvamizer is made with Anodized Aluminum Shell and 100% Surgical Grade Stainless Steel Internal parts with a Glass tank Tube.

Each Kit Includes:

• 1 Stand for building (shown in picture to the left)
• 1 piece of each of the of the following Wre sizes (approximately 12 inches long):
• 26 gauge A-1 Kanthal
• 28 Gauge A-1 Kanthal
• 30 Gauge A-1 Kanthal
• 0.5 x 0.1 mm A-1 Kanthal Ribbon Wire
• 0.8 x 0.1 mm A-1 Kanthal Ribbon Wire
• 1 piece of 1 mm Stainless Rope (for wick)
• 1 piece of 1 mm Stainless Rope (for wick)

This is a release package and only a limited amount will be sold with these accessories as supplies last.

Please do not build atomizers below 1.5 Ohm as they can be extremely dangerous and NHaler will NOT be responsible for battery and/or device failures.
An instructional video for this product is available below via our NHaler Youtube page showing how to build your very own Curvamizer:

 

[hittman]

I don't know how you find time to develop all this new stuff Drew. It must keep you hopping.

 

[Drewsworld]

I stay pretty busy....LOL...Thanks

 

[Drewsworld]

Here ya go...

 

[Drewsworld]

Here is a nice build for the Curvamizer!