- Status
Ya' know I was just trying to be playful - Right ? 
hittman said:
I saw that "My" Friend - CONGRATULATIONS - again . . . I so hope ya like it . . . And - If not let "Me" know . . . I might know someone "very special" who will take it off you hands . . .
Just Sayin' . . .
.
Where is the link, I love Mechanical Mods. Understanding Batteries, Storage Regulated Usage. Nov 2020 is a Referendum on Americans more than 45 .
Can Fully Understand - "Peer Pressure" is a horrible thing . . .
So - No Pressure Here . . .
Well - I hope ya' can finally stand your own ground then and even take a stand above the crowd to decide for yourself whats is going to be happening in your future . . .
AND - Even with that being said . . . Just As An FYI: I would be remiss if I didn't say that -IMHO - Just like you standing out from the crowd - the Innokin Sceptre would surely standout whether or not you had any other pods . . .
Personally, it is quickly becoming a major go to device for "Me' . . . Just Sayin' . . .
Yes - You can say I'm another pushy satisfied "Customer" . . .
.
Since my vape range is 1.5 - 2.5 I'm not needing more than 100 W
Well, I didn't, so @Uncle, one question--leaks. Have you experience any kind of leaks with your Spectre--seeping, oozing, wet feet, sudden juice dumping, excessive condensation, or just plain old leaks whatsoever? I like the device and I'm mighty tempted but I really don't need another leaky pod.
Thank you, love!
So far so good, - No Leaking at all anywhere, except the first time I overfilled the Pod (hard to do, but yea I did it 
) . . . The Pod sits nicely in the magnetic "craddle" and can only fit in one way . . . . Also you shouldn't get any leaks once the Pod's little fill flap is closed tightly - which is not as difficult to do as it is with other Pods . . . And when the Pod is properly "seatted" - No Leaks . . . Even when changing a coil and there is some liquid left - if you take care to cover the drip tip - there is no leaking . . . At least that's been "My" experience so far . . . 
BTW: Really nice prices on the Innokin Sceptre / Pods / Coils available if you go the ecig "Mafia" route . . .
Just Sayin' . . .
.
) . . . The Pod sits nicely in the magnetic "craddle" and can only fit in one way . . . . Also you shouldn't get any leaks once the Pod's little fill flap is closed tightly - which is not as difficult to do as it is with other Pods . . . And when the Pod is properly "seatted" - No Leaks . . . Even when changing a coil and there is some liquid left - if you take care to cover the drip tip - there is no leaking . . . At least that's been "My" experience so far . . . BTW: Really nice prices on the Innokin Sceptre / Pods / Coils available if you go the ecig "Mafia" route . . .
Just Sayin' . . .
.
Last edited:
I saw those on ecigmafia. I just can't decide which coils to get. Any suggestion? Does either one stand out to you?
hittman: 22813055 said:
Well - To be absolutely honest, as a MTL Vaper, I tend to shy away from any coils that are sub-ohm . . . Even with that said, I do find the 1.2 ohm coils to be extreamly efficient and great to use for "My" NEEDS . . . Matter of fact, even with the air flow adjusted to it's lowest setting for MTL - I've been getting more then enough vapor for even a "Cloud Chaser", especially when using the "Draw" option (nothing at all like the auto draw of a carto - difficult to draw, bearly got any vapor, nor satisfaction back then) . . . At least when using the "button" I can somewhat limit the vapor - however still a lot . . . So when all is said and done - if you are even close to the vaper I am - IMHO - a 1.2 coil will serve your NEEDS as well . . . BTW: Many vendors don't have everything available right now and are much more expensive the ecigmafia which has the best prices for the Sceptre ($19.99) /Pods ($5.99) /Coils (5-pack $5.49) right now . . . Hope this information is helpful . . . Just Sayin' . . .
.
Well - To be absolutely honest, as a MTL Vaper, I tend to shy away from any coils that are sub-ohm . . . Even with that said, I do find the 1.2 ohm coils to be extreamly efficient and great to use for "My" NEEDS . . . Matter of fact, even with the air flow adjusted to it's lowest setting for MTL - I've been getting more then enough vapor for even a "Cloud Chaser", especially when using the "Draw" option (nothing at all like the auto draw of a carto - difficult to draw, bearly got any vapor, nor satisfaction back then) . . . At least when using the "button" I can somewhat limit the vapor - however still a lot . . . So when all is said and done - if you are even close to the vaper I am - IMHO - a 1.2 coil will serve your NEEDS as well . . . BTW: Many vendors don't have everything available right now and are much more expensive the ecigmafia which has the best prices for the Sceptre ($19.99) /Pods ($5.99) /Coils (5-pack $5.49) right now . . . Hope this information is helpful . . . Just Sayin' . . .
.
Thanks! I like the 1.2 pods on the Xros and use 1.2 coils on the zeniths and zlides. I do both mtl and dtl throughout the day. I think I'll grab a few boxes of the 1.2's. Even if I end up liking the .5 coils then I can go back and get some later.
Yep - 1.2 (harder to get now) or 1.6 w/ Zenith or Zlide . . . BTW: I do notice I am going through more e-liquid with both the Zlide and Sceptre given their respective vapor production, especially compared to the Zenith . . . Just Sayin' . . .
.
I prefer the 1.6Ω coils on my Zlides, so if Sceptre with 1.2 coils is similar to that, I'll be happy. Thanks, Uncle!
And now--gray or white?
And now--gray or white?
I prefer the 1.6Ω coils on my Zlides, so if Sceptre with 1.2 coils is similar to that, I'll be happy. Thanks, Uncle!
And now--gray or white?
Absolutely No Problem . . . Glad I could help . . . However, not gonna be any help about colors sine "My" preferrence is the Black w/ Red highlights and the Blue w/ Blue highlights . . . Just Sayin' . . .
.
Last edited:
AAbsolutely No Problem . . . Glad I could help . . . However, not gonna be any help about colors sine "My" preferrence is the Black w/ Red highlights and the Blue w/ Blue highlights . . . Just Sayin' . . .
.
Well, That's "Your" preference.
Just sayin'...
I prefer the 1.6Ω coils on my Zlides, so if Sceptre with 1.2 coils is similar to that, I'll be happy. Thanks, Uncle!
And now--gray or white?
I’d pick the white.
I like the white too, but I'm worried (just a little) about that slippery finish. All the other colors have more grippable, matte, rubbery finishes. Oy.
I really hope you will enjoy it. I love mine (I was lucky enough to snag one of the special edition ones sold through vendor so been vaping it a while)
One more question before I buy one--it's already in my cart.
I have a Minifit (which I like) and two Vinci X. The most appealing to me features of the Vincis is that there are several RBA coils for them already on the market, among them, the Voopoo RBA (postless deck) and this little gizmo with two posts:
Reewape RUOK RBA Coil for VOOPOO VINCI/VINCI X Kit single coil
Having a good RBA coil for a pod would be a much safer way to go, considering what's happening right now. Any thoughts?
Is this new Sceptre considerably better than the Vinci X with a couple of RBA coils? What if we can't get replacement coils for it in the future?
Apologies to @Uncle for veering off topic.
- Status
Similar threads
- Locked
