Ok, so for the last month I have trying out a new wick. It is porous ceramic, this wicks as good as 400 SS mesh IMHO. I have gone through about 12 tanks on this wick and coil. Here is a pic of the wick on the top. The wick on the bottom is 400 SS mesh.
Here is the wick after 12 tanks of juice:
And here is a pic of the wick down in the tank:
It was produced by a company for an individual, I am not nameing names yet as I have been a beta testor for this wick. I have tested a 1/8" and a 3/32" wick. The pics above show the 3/32" wick in a DUD. I have been given the green light to post my findings from the individual responsible for its creation.
The benifits are there is no need to oxidize, setup is quick and it wicks great. Also I was told that after it gunks up from juice you can remove the wick and tourch it red hot and the wick looks like new again. I have not tried this yet as it is still performing great. It did take a couple tanks for it to break in and really get going. But once that is done it works and tast better than any SS wick IMHO.
The down side, and the only one I can find, it is fragile. Any excessive side force will break the wick. I have wrapped all the coils on the wick off the atty and then connected once wrapped. I am currently running 32ga kanthal @ 2.5 ohms @ 10 watts of power and it is awesome!
I will be out of town for the next 3 days, but wanted to post my findings to date.
I do know of an up comming Co-Op will be offering these with the PV and atty that are being designed and I know one vendor so far that will be carrying these.
Let me reiiterate these are not mine, I am only a beta testor and am not running any co-ops nor selling these. These are being made for another member that wishes to remain anonomous at this time.
When I know more I will post updates.
Dan
Here is the wick after 12 tanks of juice:
And here is a pic of the wick down in the tank:
It was produced by a company for an individual, I am not nameing names yet as I have been a beta testor for this wick. I have tested a 1/8" and a 3/32" wick. The pics above show the 3/32" wick in a DUD. I have been given the green light to post my findings from the individual responsible for its creation.
The benifits are there is no need to oxidize, setup is quick and it wicks great. Also I was told that after it gunks up from juice you can remove the wick and tourch it red hot and the wick looks like new again. I have not tried this yet as it is still performing great. It did take a couple tanks for it to break in and really get going. But once that is done it works and tast better than any SS wick IMHO.
The down side, and the only one I can find, it is fragile. Any excessive side force will break the wick. I have wrapped all the coils on the wick off the atty and then connected once wrapped. I am currently running 32ga kanthal @ 2.5 ohms @ 10 watts of power and it is awesome!
I will be out of town for the next 3 days, but wanted to post my findings to date.
I do know of an up comming Co-Op will be offering these with the PV and atty that are being designed and I know one vendor so far that will be carrying these.
Let me reiiterate these are not mine, I am only a beta testor and am not running any co-ops nor selling these. These are being made for another member that wishes to remain anonomous at this time.
When I know more I will post updates.
Dan
Last edited: