-
Need help from former MFS (MyFreedomSmokes) customers
Has any found a supplier or company that has tobacco e-juice like or very similar to MFS Turbosmog, Tall Paul, or Red Luck?
View thread
The Overlooked Tootle Puffer Gear Thread
- Thread starter roxynoodle
- Start date
- th_trl_thread_readers 0
- Status
I don't doubt you. Y'all also use super thick eliquid which would slow down seeping into the atty chamber. I vape 70/30 which requires a jfc or bottom fill.
I just tried that, Roxy, and it works like a charm. And here I've been going through this rigamarole of closing the AFC, filling, letting sit for 10 seconds, turning it upside down for 10 seconds, turning it back over and finally opening the AFC again. That works but is really a PITA.
You might want to try one of these on your 3.1, I have one on mine but I had to file down the edge of the top part a little as it would bottom out before it sealed. A few minutes with the file or sand paper and you are good to go.
https://www.fasttech.com/products/1815409
Here it is on the right, I'll have to check and see if that KF4 top cap (left) will work one of these days, that would be an even better way to go.
That's really cool, TD. I just added it to my wish list. It basically works like an Erl does.
Do you still need to close the air holes when you fill with it?
Actually, I mostly use 50/50. I don't like high vg. I have allergy induced asthma. So from April til November, high vg doesn't go over well with me. I never use higher than 70vg.
I just tried that, Roxy, and it works like a charm. And here I've been going through this rigamarole of closing the AFC, filling, letting sit for 10 seconds, turning it upside down for 10 seconds, turning it back over and finally opening the AFC again. That works but is really a PITA.
That's really cool, TD. I just added it to my wish list. It basically works like an Erl does.
I don't even have the afc ring for my Erlk. Its previous owner misplaced it. Never used them on my clones either. And none have ever leaked using the fast fill
. Yes, so nice and easy.
I don't even have the afc ring for my Erlk. Its previous owner misplaced it. Never used them on my clones either. And none have ever leaked using the fast fill
Am I right in assuming you were the previous owner, Katya?
No....
I'm still a proud owner of two minis from FT.
I tried. I tried so hard--just ask Roxy. She tried to help me in her Erl thread. So did many others. The blasted things leak, either right away or after a while, a little or a lot, anything from a catastrophic juice dump to a wet foot... Oy.......
And I'm not an idiot. I can recoil and wick other RBAs without any problems, I swear!
Last edited:
No....
I'm still a proud owner of two minis from FT.
I tried. I tried so hard--just ask Roxy. She tried to help me in her Erl thread. So did many others. The blasted things leak, either right away or after a while, a little or a lot, anything from a catastrophic juice dump to a wet foot... Oy.......
And I'm not an idiot. I can recoil and wick other RBAs without any problems, I swear!
Its that Murphy's Law about how some attys just don't like some people.
Actually, the PO of my Erlk loves them, and had 6 or 7
Its that Murphy's Law about how some attys just don't like some people.
Actually, the PO of my Erlk loves them, and had 6 or 7
Exactly right.
My best and most beloved never-leak never-had-an-issue RTA is my idiotic Kayfun 4.
Its that Murphy's Law about how some attys just don't like some people.
Actually, the PO of my Erlk loves them, and had 6 or 7
Don't tell anyone, but I now have 8.
Exactly right.
My best and most beloved never-leak never-had-an-issue RTA is my idiotic Kayfun 4.
And mine went bye bye
Don't tell anyone, but I now have 8.
LOL! Why not? Apparently they love you, and such good flavor.
Well, folks, I think the Bellus may be that rare RTA that can suit nearly everyone. It can tootle single coil, or handle high power builds. I did find setting the coils high to let that side airflow hit underneath the coils increases the flavor, which is very good. Its easy to wick. I just cut my wicks to the bottom of the channels as I'm using a 50/50 juice. It fills like the Erlkonigin, but I used my usual top filling method of closing the afc (yes, Boden ), filling, and flipping for the last part of securing the top cap, and opening afc inverted. Worked perfectly.
I think this is a great tank, especially for the price. I got it from Efun Top for $18.50 + $4 shipping.
The only con, for some, is that you can't get huge coils in it. Most of you who are participating in this thread will be fine with that
), filling, and flipping for the last part of securing the top cap, and opening afc inverted. Worked perfectly.I think this is a great tank, especially for the price. I got it from Efun Top for $18.50 + $4 shipping.
The only con, for some, is that you can't get huge coils in it. Most of you who are participating in this thread will be fine with that
Uh-huh....
Yeah right.
Bellus? Hmmm.... Off to research the Bellus!
Well, it has 2 holes in the top for filling
That's the video I saw like 1 minute of, and then my bird turned off, lol!
I did some things differently (because of course any two humans will). I put my coil(s) higher, and took my wicks to the bottoms of the channels. I also used a 50/50 juice. I took a look at those two big slots in the chimney barrel/chamber and thought it might feed the deck quickly so went with the long tails.
Oh, and Katya, you could bottom fill this right through those slots in the chimney barrel/chamber and not deal with top filling at all.
I did some things differently (because of course any two humans will). I put my coil(s) higher, and took my wicks to the bottoms of the channels. I also used a 50/50 juice. I took a look at those two big slots in the chimney barrel/chamber and thought it might feed the deck quickly so went with the long tails.
Oh, and Katya, you could bottom fill this right through those slots in the chimney barrel/chamber and not deal with top filling at all.
- Status
Similar threads
