You can bang the series deck in so a dual coil won't half the resistance so you can put anything in there, that's the beauty of it.Given how big those coils need to be, it must be pretty hard to get below 1 ohm without using wire hanger gauge. So, how is it at mtl ? [emoji41]
Be careful with the series deck on the Titan, folks have melted the PEEK insulators from too much heat. It was user error for sure but quite easy to do.![]()
Yes it doubles as the coils are in series. Series decks were designed for mechs so you didn't have to put 20+ wraps on each side to get above 0.4 ohms.Sorry, I think with the series deck, the resistance doubles,
@TrollDragon can you clear this up, the series deck is new to me....learning all the time :/
Thanks for clearing that up, I know the series deck was for mechs that throw out 8.4V but with the resistance doubling, I could run massive staggered fused Aliens in it on a regulated mod which normally would be too low and draw less amps.Yes it doubles as the coils are in series. Series decks were designed for mechs so you didn't have to put 20+ wraps on each side to get above 0.4 ohms.
I forgot to mention that the insulators were melting from glowing chunky coils to remove hot spots, not with regular use.
that's gotta lil purple on it
kewlios.........hope you love it!Ordered the Gaia mod. Going to wait on mjag's review for the Cylon.
Love it!!!@Debadoo ....Hopes ya like it xx
uhmmm that fits!this tank will only be for a few people, probably the ones that are a little "unstable" LOL
you too darlin! Just for the holidays ya mean.....or more than that?Merry Christmas to y'all, have a good one as I won't be around for a while.
Maybe you just need to equalize the tire pressure?
Good to hear that the recovery is proceeding, even if not as quick as wished for.![]()