Thick juice in in tanks

Status
Not open for further replies.

Pandus

Full Member
Jun 17, 2012
11
0
Saitama, Japan
I just ordered my first DCT from madvapes, along with some Boba's bounty and hype. I ordered the 1.5 and 3.0 ohm triple hole pre-punched cartos from madvapes and will be vaping on a maxi roughstack at 3.7 and 7.4v. I hear that boba's is one of the thickest juices out there. Should I expect burning or dry hits at 7.4v without enlarging the carto holes?
 

The Hill Giant

Ultra Member
ECF Veteran
Verified Member
Jun 5, 2012
2,834
6,769
44
Providence
Sorry to hijack, but I have a similar question...

So I'm using mostly Ms. T's liquids, which don't give the specific VG/PG ratio, but it does say on her site that they are a little more VG than PG (I'm assuming it's 60VG/40PG).

How many holes should I punch in a single coil cartomizer to use with her juice and a DCT?
 

casino

Full Member
Jun 15, 2012
30
30
Las Vegas
Slotted cartos work much better with thicker Juices. Not everyone is comfortable cutting them with a Dremel. There are several Videos on Youtube on how to do so. A good one is by Pbsardo.

Thicker %100 vg juice will need a bigger whole if your just going to use a punched carto. Save yourselve some $ and just go to a homedepot or lowes and get a Saddle clamp from plumping dept the work great and are a lot cheaper then most carto punches online.
 
Status
Not open for further replies.

Users who are viewing this thread