I looking into getting a tank and was going to punch my own cartos instead of paying more for the pre-punched ones and noticed some people were using a Dremel to cut a little slot in the carto. So which one is better?
I use a dremel because that's what I have I believe that saddle valve would work well too, I've noticed it doesn't matter how big or small the hole is or one slot or 2 slots anyway you do it it seems to work with a boge carto now the DCCs are a different story I could never get them right I had a lot of over wicking problems even if I use an 18 gauge needle to punch the holes
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.