too much juice???

[M0T080]

Hello all, I've been using a MV902 and filling with my own juice, I have read all the cart mods and I am testing 5 different variations right now, but I keep running into the same situation and I am curious if this is normal or not.

every time I put in a new refilled cart and give it a couple of puffs and then pull the cart off, the cart is covered in juice. Am I using too much juice? Am I taking too hard of a drag? I feel like I am wasting half the juice that gets stuck to the side of the cart.

I usually put in about 10 drops, put in my filler and add about 5-10 more drops.

any guidance appreciated

 

[jiveman]

Judging by your last count of how many drops, yes you're using too much juice. If you're putting in 10 drops, then the filler, then 5 to ten more, that's a bit much.

If you're using traditional filling methods, I wouldn't put drops in before the filler. I'd drip those drops directly onto the filler before you put it into the cart.
Then top it off with about 6 or seven drops.

I've noticed I can't really exceed 12 drops or so or I get that problem.

Maybe use about 8 drops on the filler itself, put the filler in the cart, then drop about 4 on top until you notice it looks a little mushy but not entirely a puddle.

Then put a drop in the atty and puff away.

 

[Caddyman]

i would like to know if this is normal as well. mine dont leak per se while in use but if i store them, even standing up atty up, they leak from the seam where the atty meets the cart.

i am using highpings mod for a 510. open res in bottom and just a poly plug up top.