Tootle Puffers, Redux (The Sequel)

Status
Not open for further replies.

juskiddin

Ultra Member
ECF Veteran
Jul 29, 2015
1,295
10,129
Canada
Sounds like it's not wicking well; is your juice high VG? If you could thin it down, OR, turn down the power on the mod, it might do better.

Andria
Thanks Andria, I'm not able to adjust the power because it's a simple (lowly?) ego one. The juice is a fairly high vg so I think I'll dump it, try (yet another) new coil and some different juice and give 'er a whirl.
Digits crossed.
Thanks for the help everyone!
 

juskiddin

Ultra Member
ECF Veteran
Jul 29, 2015
1,295
10,129
Canada
Well, the sun is over the yardarm... somewhere!

Maybe a batch of bad or mis-marked coils? Do you have any way to measure them?
Unfortunately I don't @DavidOck. I actually tried 2 different coils from 2 different packs with the same result. Dang it :(
And yes! - you're right about the sun over the yardarm somewhere! I like your positive outlook :)
 

MikeyConti

VapeBro
ECF Veteran
Verified Member
Jul 22, 2014
3,885
17,524
35
South Carolina
Was not me either. However I am interested in the top fill thingy for the STM. It might become my first FT order.
I am really liking my STM with the 1.2 coil. Perfect draw for me and the vape is just warm not hot at all.
I actually ordered a 5 pack of coils for it. Go figure...
will likely never use the .5 ohm coil that came with it, but who knows? Never say never.
Might see me in a twerking Klowd comp someday?
You talking about the actual Kanger Top Fill Adapters? Heres some at the very bottom of the page.. I have never used one though.
KangerTech e-Cig Clearomizers & Tanks

Edit* Pretty sure Sweet-Vapes sells them as-well.
 
Last edited:

gadgetkeith

Super Member
ECF Veteran
Verified Member
Jul 12, 2015
703
2,805
Heber Srings Arkansas
@#@*!!#!!...

Jinxed it...spoke too soon. Burnt :(

Where's that bottle of scotch?!!

if juice is to thick and not wicking fast enough then a couple of drops of water or a little more pg to thin it

but if scotch works also then why not hey

just kidding

good luck and hope you get it sorted out
 

Robert Cromwell

Moved On
ECF Veteran
Feb 16, 2015
14,009
65,472
elsewhere
Any idea why my protank 2 coils keep burnin on my ego one? Put a new one in yesterday and 1/2 hour later...burnt. Tried another...burnt. If I take a short pull it's fine but a longer pull..burnt.

I've been absent for quite some time. So, hello again y'all!!!
You either need a higher resistance coil (probably) or a thinner juice if you are using above a 50/50 juice.
 

Robert Cromwell

Moved On
ECF Veteran
Feb 16, 2015
14,009
65,472
elsewhere
Thanks Andria, I'm not able to adjust the power because it's a simple (lowly?) ego one. The juice is a fairly high vg so I think I'll dump it, try (yet another) new coil and some different juice and give 'er a whirl.
Digits crossed.
Thanks for the help everyone!
You need a 2 or 2.2 ohm coil. Factory Kanger 1.8's are bad to burn on an unreg battery.
 

fourthrok

Vaping Master
ECF Veteran
Verified Member
Aug 12, 2012
3,192
7,709
Watertown, NY
You need a 2 or 2.2 ohm coil. Factory Kanger 1.8's are bad to burn on an unreg battery.
I remember I used to use 3ohm on my mechanicals back in the day. Don't really recall the reason why...but it seemed to work out pretty good for me. I was using my (usual) 85PG/15VG mix, however. I'm not a fan of VG, and only use a little to pump up the vapor a little and add a touch of "smoothness" to my juice.
 
Status
Not open for further replies.

Users who are viewing this thread