Troubling Zmax Rev 2 PCB

[Barn Burner]

I recently purchased a Zmax Rev 2 printed circuit board from mad vapes... but having never owned a Zmax and the fact that mad vapes provided no documentation, I'm a little baffled on how to wire it up. It has a red wire and a black wire and I assume they are for input power, but where is the output? Any help would be appreciated.

ZMax Rev 2 Printed Circut Board

 

[JeremyR]

Red goes to the positive on the 510, black goes to common ground typically the mods 510 cap that grounds back to the negative battery side through the body. . Battery positive connects to the switch side of the board, the soldered disc on the end of the board.

 

[Barn Burner]

Thanks!

 

[JeremyR]

This is how it's laid up in the zmax v3

Newer oled board but..

Oh I was just gonna mention since your building. It will only Put out 4 amps with stacked 18350 batteries. Otherwise its 2.5 amps with a single battery.

 

[Barn Burner]

Stacking 18350 IMR's. Plenty for me.

Thanks again.