tsunami top cap. how do you make it easy to remove?

[aalmosawi]

just a quick one for you guys.

perhaps a tip or two on how to make the top cap easily removable from the tsunami.

i have tried putting ejuice on the orings, even somewhat soaked it with hot water.
when i come to close it and then come to take it off it is always always always a struggle and i fear for my 510 on my rx200 or ipv3li (whichever i have it on at the time)

(on a side note i have the same trouble with the wismec indestructible but thats another story)

 

[Sanctuary Denied]

That top cap is kind of a bugger.
I wrapped my wicks through the center slightly and drip down the middle to keep the juice from rolling off the coils and down into the air intake.
I kind of wiggle it back and forth when I do need to take off the cap, but be careful, some times one of the O-rings likes to come off with it.

 

[aalmosawi]

That top cap is kind of a bugger.

exactly.
i see youtube videos where they remove it with ease. mine is like literally jammed!
i wouldn't care if i dotn worry about my 510 on the mod.

 

[Ravenscroft]

On the base section it was the top o ring that was giving me that problem.

I took that o ring off and used it like that for a day and it worked.

I was going to throw the thing away before this.

I then found a thinner o ring that I had from a Kayfun or some atty like that ( it was in an umarked spares Bag) and used that in place of the original one.

It works well now with no struggle and no swearing.