What's a good build for the Tugboat v1 and v2 that uses 22-26 gauge wire? Somewhere close to .5 ohms or higher?
Tugboat V1 and V2
- Thread starter Kane Tha Mighty
- Start date
- th_trl_thread_readers 0
- Status
26g 6 wraps around a 3mm bit dual coil comes out to about 0.58ish ohms. Do 5 wraps instead and it will be closer to 0.50.
I recently did a twisted 26g dual coil in my tugboat v2 2.5mm id 5/6 wraps, comes out to 0.26 and vapes like a beast, killer flavor.
These coils barley fit into the post holes but it was worth it.
I recently did a twisted 26g dual coil in my tugboat v2 2.5mm id 5/6 wraps, comes out to 0.26 and vapes like a beast, killer flavor.
These coils barley fit into the post holes but it was worth it.
anybody using nichrome on a tugboat? pretty soon im getting some .3 ohm nichrome coils (getting pre-wrapped becuase i dont have materials or ohm meter).
- Status
Similar threads
