Just did this, and it works pretty good. Used a Volt 808 carto
Step 1:
Gingerly remove the filament from the cartomizer
Step 2:
Add your favorite flare (Austin Powers sticker)
Step 3:
Cut a section out of a pen cap (they taper, so it will fit snuggly in the mouthpiece end) to make a
primitive drip tip
Step 4:
3 drops of liquid to the side, 2-3 on the air tube
Step 5:
vape it up
Step 1:
Gingerly remove the filament from the cartomizer
Step 2:
Add your favorite flare (Austin Powers sticker)
Step 3:
Cut a section out of a pen cap (they taper, so it will fit snuggly in the mouthpiece end) to make a
primitive drip tip
Step 4:
3 drops of liquid to the side, 2-3 on the air tube
Step 5:
vape it up
Last edited: