Twisted 26g in subtank mini rba?

Status
Not open for further replies.

eddiea

Super Member
ECF Veteran
Sep 8, 2014
326
417
Laguna Niguel, CA USA
    Hey everyone, still a pretty amataur coil builder but I was wondering if anyone has any experience trying to get a twisted 26g into the mini v2 rba? For the life of me I cant get the wire to really trap down. Ive had no problems in rdas but this build deck seems to like to fight me lol.

    Sent from my GT-N5110 using Tapatalk
    Try 6 wraps at the most for compressed/contact coils, or less wraps for spaced coils.
     

    eddiea

    Super Member
    ECF Veteran
    Sep 8, 2014
    326
    417
    Laguna Niguel, CA USA
      As I mentioned previously, 6 wraps is fine but use a 2.5mm ID (because airflow will suffer if you go higher). Here's a twisted 26g Titanium 2.5mm build I did a couple of weeks ago...it performs well:

      Ygcxo4H.jpg
       

      cj081283

      Senior Member
      ECF Veteran
      May 15, 2015
      175
      150
      29
        As I mentioned previously, 6 wraps is fine but use a 2.5mm ID (because airflow will suffer if you go higher). Here's a twisted 26g Titanium 2.5mm build I did a couple of weeks ago...it performs well:

        Ygcxo4H.jpg
        Thanks for the tips. I did either 4 or 5 wraps around a 2.4 mm screwdriver and I managed to get it situatated at .35 ohms. The flavor and vapor production are way better now...and juice consumption is way higher now. [emoji57]

        Sent from my GT-N5110 using Tapatalk
         
        • Like
        Reactions: eddiea
        Status
        Not open for further replies.

        Users who are viewing this thread

          ')