Went to visit an old build I did back last October but this time a quad. Quad 24g 3/32 I.D. 2wrap-split 2wrap. I had originally used a .4ohm build to test the Venturi atty by @neovapetek and I knew it was going to hold up well. I wasn't sure how it would do under a low ohm build. Once @neovapetek posted they were going to have an open airflow cap I just had to try it. The atty did magnificent under a hot build! When you start getting into more than 4-5 wraps try this coil out. What it does is eliminate the hotspot burn that occurs in the very middle of a very long wrapped coil after a long drag. On a coil with alot of wraps, energy will always start at the weakest point of the circuit. (In your coil in the very middle) As all you builders have noticed the initial burn starts in the middle of your coil and goes outwards because the weakest part is in that very middle of your coils. Start out by doing two wraps then on the third wrap bend back into a "U" or "V" shape then wrapping the other way the same. This coil splits up any long coil wraps and concentrates on not just one "weak" part of the coil. Thus speeding up the burn and most of the time having a more dense burn due to the bigger hotter overall wicked area. Hardest part about it is maybe the test fire and adjustment to remove any initial hotspots. Try it out I'm sure you will enjoy it. I hope I did not confuse anyone on the explanation if I did you guys know how to get a hold of me. Thanks for checking it out and I'll post the fire vid in a bit. Build is suggested to use a 26650 hardware. Remember to vape safe, master the safety precautions of vaping and encourage proper vape etiquette! Checkout my page on facebook.com/deedupdex or instagram.com/deedupdex for more! Or checkout my ECF thread here on my SIG!
Fire Clip!!! Please turn speakers down! Click on Picture
Thanks for the support vapefam!!!!
Fire Clip!!! Please turn speakers down! Click on Picture
Thanks for the support vapefam!!!!
