UD Goliath V2

[Zilvinas_Miliauskas]

Hey guys,
I have problam. I wicked my coil which is 7raps 26g. Single coil or 8 raps 26g. Dual coil on 2.4 mm srewdriver. But i'm getting aweful burning gum material taste. I've been vaping for 3 years and i've been building coils since the beggining of vaping and i never had similar problams. Same coils have been working just fine onKanger subtank and Footoon aqua se at same wattage ~22-30w. Do you have any sugestions whats wrong. Maby it's insulators? But i can't take it apart to reach them.
Thank you in advance.

 

[Bad Ninja]

Did you wash it thoroughly before you used it?
I love UD gear but they are known to arrive covered in machine oil, which will give a nasty taste.

 

[Zilvinas]

Thank you for you time But yes, i did. I washed it with hot watter several yimes now, but it's the same awefull taste. I knoe it's not burning cotton though. I just don't know what else i can do about it I had high hopes about this RTA


Sent from my iPhone using Tapatalk

 

[Bad Ninja]

Thank you for you time But yes, i did. I washed it with hot watter several yimes now, but it's the same awefull taste. I knoe it's not burning cotton though. I just don't know what else i can do about it I had high hopes about this RTA


Sent from my iPhone using Tapatalk

Honestly, my first thought is the water didn't remove the oil.
I scrub mine with a toothbrush and degreaser, then wash it with dish soap and hot water a few times.

Beyond that it could be the wick.

 

[Zilvinas_Miliauskas]

Honestly, my first thought is the water didn't remove the oil.
I scrub mine with a toothbrush and degreaser, then wash it with dish soap and hot water a few times.

Beyond that it could be the wick.

Thank you, man. i will give it a shot one more time and I'll use your advise.
Have a nice evening.

 

[Zilvinas_Miliauskas]

Honestly, my first thought is the water didn't remove the oil.
I scrub mine with a toothbrush and degreaser, then wash it with dish soap and hot water a few times.

Beyond that it could be the wick.

Thank you, man. i will give it a shot one more time and I'll use your advise.
Have a nice evening.

 

[VHRB2014]

Some of these atts you have to take apart down to the post and insulator. The oil will get caught in between the post and insulator and then get leached out once its got wick and is running warm, pushing the oil into the wick. I have had a few that did this and the only solution was to remove the center post and clean thoroughly. I know the flavor of machine oil well, LOL. Yech!

 

[Zilvinas]

Man, thanks for your thoughts. That wouldn't be a problam to take apart and clean it, if it would be possible But it isn't. I'll try one more time though.


Sent from my iPhone using Tapatalk

 

[Zilvinas]

Looks like that the only thing that helped a lttle bit was boiling in water two times for 5 min all parts. Seems okey for now.


Sent from my iPhone using Tapatalk