UFS2 for Dummys P2

[R.D.Sponge]

Take a look here, it's one of Zoranth's illustrations, and you'll figure it out immediately.
If you try to put Iatty base in the V2 upper body, you'll see that it will not fit, because V2 upper body is thicker than V1. The good thing is that the part with the threads is the same for both, so if you could just whet the rest of the U.B. then Iatty would fit in it. Or, if you have a spare Iatty base, you can try to make it thinner. The goal is to make Iatty base pass through the extra upper body.
Or else you'll need an extra UFS V1 Upper Body.

In any case I believe it's worth a try.

 

[Huffelpuff]

The Ody Drip Mode base is narrow - shoud work w/ a small mode mouthpiece and extra upper body part, no?

 

[R.D.Sponge]

I haven't try Ody in the UFS because I think Ody in long mode is more than enough, but yes all you need is an extra upper body part.

 

[Huffelpuff]

K! Excited to try it. Have just the UFS and Ody Drip Mode and figured could combine if I want tank + rebuildable.

 

[R.D.Sponge]

You can watch the video Odysseus inside UFS, with imeo's instructions.

 

[rwechsler]

Take a look here, it's one of Zoranth's illustrations, and you'll figure it out immediately.
If you try to put Iatty base in the V2 upper body, you'll see that it will not fit, because V2 upper body is thicker than V1. The good thing is that the part with the threads is the same for both, so if you could just whet the rest of the U.B. then Iatty would fit in it. Or, if you have a spare Iatty base, you can try to make it thinner. The goal is to make Iatty base pass through the extra upper body.
Or else you'll need an extra UFS V1 Upper Body.

In any case I believe it's worth a try.

I only have 1 iatty base, which I have the tools to modify, but I wouldn't want to (don't know if I'd ever get a replacement!). I'm down to attempt grinding down a upper body from a v2 though. If all else fails, I can always just use a tiny 510-510 adapter. Could also add extra top tubes that way!