I was getting tried of My mod falling over, the battery not fitting, the button getting stuck, the body heating up due to resistance. No longer! I think the driver board in the V2 is decent when it can run off two batteries, so I present it's new home. A heavily fortified soldered inner brass case with beefy aluminum covers. It has 2 x 18650s for 7.4v with protection pcb and recharge port. I put a bunch of holes in the bottom so if it needed to "vent" it will go in that direction. It should be ubgradeable into the future. It puts out 20w but only drives down to 1.3 ohms with this board. I used an anti-vandal switch, they look cool and are sturdy. It's on the big side at 3.5" x 2.8" x 1" but a huge improvement functionally over the old tube.
She is not that pretty but built like a brick house. Impact resistant design only leaves the floor to worry about.
[/URL][/IMG]
[/URL][/IMG]
[/URL][/IMG]
[/URL][/IMG]
She is not that pretty but built like a brick house. Impact resistant design only leaves the floor to worry about.
Last edited:
