Vamo 3 510 connection

Status
Not open for further replies.

Trayce

Moved On
ECF Veteran
Mar 28, 2013
830
495
Multiversal
Does the Vamo 3 have a higher 510 connection then the Vamo 2? They say not to overtighten and if I don't then it constantly won't fire...and yes I have tried raising the center pin. I just don't want to have to keep doing that cause Im afraid I might break it.

Thanks!

By the looks of your post count you know far more than I do, but you don't happen to be using protected batteries, are you? I've read these interfere with the Vamo's protection circuitry and cause problems like the one you are describing. IMRs are the ones to use with the Vamo.

If IMRs are being used and if cranking it down just a bit more gets it to fire then maybe you're just being too careful? Or does cranking it down cause the pin to sink into the grommet? Some people fixed that by replacing the stock grommet under the pin with a grommet from the hardware store. There is a thread here somewhere but here's the Reddit link: http://www.reddit.com/r/electronic_cigarette/comments/17ai9i/low_ohm_reading_on_vamo/c83uj18
 
Status
Not open for further replies.

Users who are viewing this thread