Vamo is blowing my atties

[Hezekiah]

I have tried several different atomizers with my Vamo - they range from 2.3 to 3.1 ohms. My Vamo is breaking them. It happens differently each time - sometimes its on the first use of the atomizer and sometimes the atomizer lasts a few days before it happens. When it happens, the atomizer just stops working and the ohms register as 9.9 on the Vamo. I have tried keeping the power down (seeting the volts at 3 or setting the watts at 4) but this hasn't made a difference. Has anyone heard of this issue?

 

[Deamon L. Scaduz]

From what I have seen on the internet, is your not making a solid connection with the atomizer. Don't remember what the actual fix was, but that is what I saw online. Sorry I can't be of more help.

 

[chriscamp]

Try cleaning the connection and the bottom of the atty

 

[Broodwich]

You probably have already heard of this but just to be sure, are you on the NO 2 setting?

 

[Renzuli]

Welcome , and you can try gently lifting the contact plate ,not too far , maybe a 1/16th of an inch , not all the way out . Inside the connector , on top , where you screw in your device . Use something like a dental pick , ice pick , small screwdriver , etc . This is to have a better contact with your atty , or carto . Do you have any other devices , that you can try the carto's on ??? Or do you have a multi-meter , so you can check the ohm's resistance of the carto's ??? Or you can try putting in a 510 adapter m then screwing the carto into that . I have a Vmax , and a smok Zmax , that sometimes read 9.9 . Doesn't mean the atty , or carto is dead , just that it's not making a good contact , with the Vamo . Good Luck .

 

[Hezekiah]

Thank you very much! Good advice.

 

[Deamon L. Scaduz]

Also check out this thread, if you haven't already.
VAMO OHM Error FIX!