hi, i have a vamo 3 and i have been having some problems. the batteries are fully charged, the connection, from the atti is good (brand new head in iclear 30s). but it is not putting out as much vapor as it use too. im getting two new mods soon but for the time being i want to see if i can figure this out so i can vape happy again. anyone have a solution?
vamo v3
- Thread starter thecannoliman121
- Start date
- th_trl_thread_readers 0
- Status
You might have a defective head. Do you have another new head you could put in there and see if it changes anything?
Another idea,
Take your battery out of the mod and make sure the bottom connection where the battery makes contact is clean.
Also those Vamos are notorious for the spacers wearing out. I know you said your connection is good, but check the spacer on the top of the connector between the drip well and the center pin. If it's not aligned properly it could be causing a short. Make sure your battery ends are clean also.
That's about all I can think of.
Another idea,
Take your battery out of the mod and make sure the bottom connection where the battery makes contact is clean.
Also those Vamos are notorious for the spacers wearing out. I know you said your connection is good, but check the spacer on the top of the connector between the drip well and the center pin. If it's not aligned properly it could be causing a short. Make sure your battery ends are clean also.
That's about all I can think of.
Last edited:
ya. I have cleaned all of the connections. I am stacking 18350's but it works the same when I put my 18650 in. I've replaced the washer thing on the pin, and I am running 2 ohms at 9.5-10 watts. i have checked every thing except for the head pin. can I take that out the pin and clean it? think maybe from dropping it and one of my past clearomizers leaking a lot could have caused this?
- Status
Similar threads
