Vamo V5 oled issue

[juggalofisher88]

Hey every one got a problem right now.
The current readout on my V5 doesn't seem right
I have a 1.3ohm dual coil at 10w my mod is reading a 5amp current. But following ohms law 1.3ohm at 10w should be pushing 2.7amps.
Also following ohms law a 5amp load at 1.3ohms would take 32.5w.

But if I throw on my 1.8ohm bdc tank at 10w it's shows correct current of 2.3amps.
Also my kayfun at 2.3ohms and 10w shows a correct current of 2amps.

So what gives?

Powered by Area Rom Centura 1.3

 

[Rickajho]

If the resistance of the coil is pushing the amp limit on a VAMO it automatically dumbs down voltage/wattage to protect the electronics. Considering 1.3 ohms is the lowest a typical VAMO will fire that is what most likely is going on here.

 

[juggalofisher88]

1.3ohms at 10w shouldn't be pushing the amp limit. Unless a dual parallel coil draws more amps???

I'm thinking is my rda it's an igoW I just read a list about twisted center post causing issues... maybe that is my problem

Powered by Area Rom Centura 1.3