hello, i am unsure if this is the right place, if this is gonna be a simple solution or not, but i have been vaping for about 3 months now using the vamo v5 with a nautilus (with bvc coils) and loving it. a little over a month ago i ordered the Vulcan RDA. had a little bit of trouble at first, but a couple of coworkers showed me how to build it and helped me get up and going. unfortunately my latest problem is stumping them. i tried a build one of them had on their tobh RDA and it hit so much better, so i asked what was different from his to mine, his reply was a lower ohm and a higher voltage, so i tried it. the problem i keep coming to is my coils measures out on the vamo to be 0.7-0.9 (around 8-10 wraps of 28 or 30 gauge wire on a 3/32" diameter) and then all the vamo does when i push the fire button is display the ohms, it doesnt fire. either that or it fires fine when i test it, go outside for a smoke and only get 3 puffs before it goes back to doing the same thing. when i asked the guys here about it they said it might be that the vamo wont fire below 1 ohm, but that doesnt make sense to me if it works for intermittent periods of time. i have built a dozen or so coils and tried it, always the same result. any thoughts?
Vamo v5 w/ Vulcan
- Thread starter imscuba
- Start date
- th_trl_thread_readers 0
- Status
- Status
Similar threads
