Vamo'd my first eVod

[LeoRex]

Ok, one of the tricky things about the Vamo and BCCs is that with the recessed ego threads, you run the risk of unscrewing the clearos base by accident since if you keep the ring on, you have to grab the tank and not the base.

Well... I was sitting there, but really paying to close attention when I went to remove my eVod. I pulled it up... yep, base still attached!

Zoinks! I immediately to it up, expecting a track full of juice all over the place. And as amazing as it sounds... not a drop spilled. I was vaping 50/50 Legend, which must have been thick enough to stay stuck up on the eVod. Phew...safe to say that I'll be more careful from here on in.

 

[LKnives]

I tend to keep my T3S on my Vision Spinner as opposed to any of my devices where it would sit inside a drip well but yeah, did this once with my CVI and T3S. Would probably try to remember to remove it upside down if I still put anything on my CVI that wasn't my protank.

 

[JR 137]

I did that once with my Vamo V3 and Evod. I always either flip it upside down and take off the Evod or remove the drip well ring and remove the Evod. I didn't have much juice left in that Evod; I was taking it off to refill it so not too much of a mess.

Live and learn.

 

[LeoRex]

Heh...this one was full...just switching to my spinner for travel.

 

[Glen Snyder]

This is why I got the V3

 

[deniz]

This is why I got the V3

same here
and I've been using the top part for air flow control with the X9 clearo i have

 

[LeoRex]

I have a V3.. . Didn't pull the ring