I guess I'm done with this tank for now. I rewicked it 4 times, changing the amount and the length of the cotton. Tried different juices with different PG/VG ratios. Tried different wattages from 10W to 35W (of course the higher I go the worse it gets). In all scenarios it's a juice sucker. I've watched 4 YouTube reviews but I'm not able to fix it. I've tried to vape with the mod on the table to not tilt it as suggested by @Figs as well, but I wasn't tilting the mod before, so that's not the issue (I noticed the reviewers on YouTube tilt the mod like they're drinking from a soda can, but I never do that). I'm not over dripping -- I get juice to the top even with the cotton almost dry.
It's one of the most unpleasant experiences I had with vaping. I have to clean the chimney with paper towel after 2 puffs and after 5 puffs I open the top cap to clean it as well. There's juice everywhere. But anyways, I never had a single good experience with all the gear I own
I think that the problem could be the coil, as pointed by @maibol. It's hard if not impossible to get spitbacks from this tank, since the airflow tightness, but I left only the deck in the mod, fired it and noticed some popping/spitting. In the name of science I've putted a napkin on top of the deck and vaped and noticed there wasn't only vapor in the napkin, but a lot of liquid juice as well. I guess all the spitback accumulates and after 3 puffs it goes up to the drip tip when I pull. I just rewicked it again, because I thought the spitbacks were caused by hot spots on the coil. I've checked and cleaned the hot spots but they were almost non existent and I had cleaned all the hotspots before my first wick. I don't know what else could cause popping and spitbacks but I'll look into it. It's strange but no one complained about the Ni80 premade coils that comes with the tank, so I guess they're ok.
Unfortunately I don't have any appropriate wire or premade coils to test on it (ordered some from China but it'll take 2 months to arrive). I'll give it another go with different coils in the future.
Thanks everyone for all the support!
It's one of the most unpleasant experiences I had with vaping. I have to clean the chimney with paper towel after 2 puffs and after 5 puffs I open the top cap to clean it as well. There's juice everywhere. But anyways, I never had a single good experience with all the gear I own
I think that the problem could be the coil, as pointed by @maibol. It's hard if not impossible to get spitbacks from this tank, since the airflow tightness, but I left only the deck in the mod, fired it and noticed some popping/spitting. In the name of science I've putted a napkin on top of the deck and vaped and noticed there wasn't only vapor in the napkin, but a lot of liquid juice as well. I guess all the spitback accumulates and after 3 puffs it goes up to the drip tip when I pull. I just rewicked it again, because I thought the spitbacks were caused by hot spots on the coil. I've checked and cleaned the hot spots but they were almost non existent and I had cleaned all the hotspots before my first wick. I don't know what else could cause popping and spitbacks but I'll look into it. It's strange but no one complained about the Ni80 premade coils that comes with the tank, so I guess they're ok.
Unfortunately I don't have any appropriate wire or premade coils to test on it (ordered some from China but it'll take 2 months to arrive). I'll give it another go with different coils in the future.
Thanks everyone for all the support!