I have one of these that I like except for having to bottom fill it cause the top is all but impossible to get loose. Any ideas on a fix?
- Status
Hmm, I think the answer may be to not tighten down all the way on that little oring.
Why is it impossible to get loose? Is it new? Maybe it was sitting for long time without using it?
Cause if so maybe u need to put it in warm water and try open it first and then lubricate the orings with some pg and then work it by opening and closing it many many times before u start to use it and when u use it just be careful not to overtighten it....
Cause if so maybe u need to put it in warm water and try open it first and then lubricate the orings with some pg and then work it by opening and closing it many many times before u start to use it and when u use it just be careful not to overtighten it....
How long have you had it, and when did you start having problems with it? I’m betting it’s cross threaded. Haven’t cross threaded mine…yet, but it is poorly machined, at least the threads for the top fill cap. Have to be very careful when putting it back on.
At least you are experienced enough to answer your own questions! haha...
I'm sorry, but that was too funny to pass up!
- Status
Similar threads
