• Need help from former MFS (MyFreedomSmokes) customers

    Has any found a supplier or company that has tobacco e-juice like or very similar to MFS Turbosmog, Tall Paul, or Red Luck?

    View thread

VaporEngine Deals, Reviews, Vaping Discussions.

Status
Not open for further replies.

Mommay

Super Member
ECF Veteran
Verified Member
Jan 19, 2014
395
1,307
Arkansas
You could just send one to Mommay and one to me. Then you only have three winners to pick later. See, I'm just trying to make your job easier Mike. I promise that is all it is. :D

I think that's a WONDERFUL idea, MikeNice81... afterall, that would STILL be an awsome contest--- with 3 Kayfuns! Besides, this would be my first rebuildable atty tank - yours too, I bet. I think your idea is just STELLAR! :toast:
 

CountBoredom

ECF Guru
ECF Veteran
Apr 11, 2014
29,193
53,298
San Diego, CA, USA
The Xtar VP2 charger I picked up about a month ago showed information on the charging display panel when I first started charging, but sometime in the middle of charging my first battery, the display just went blank and no longer shows anything. When I returned to check on the status of my batteries, I could see nothing except the red/green LEDs for each battery.

It should look like this:
XTARVP2Display_large.jpg

but, instead, it stays completely blank.

The charger still works--after a while, the LED goes green and the battery reads fully charged on my Vamo--but I'm operating on pure guesswork for selecting the charging rate (shown in the center column on the display). Pressing the button above the display appears to still work (the time it takes to charge a given battery lengthens or shortens if I press the button in between charges); but I am not sure if the charge rate resets each time I unplug the charger, so I'm never exactly sure of what rate I am using.

The instructions for the charger are rather minimal, so I have been unable to figure out if there is a way to turn the display back on. Any thoughts?
 

vapour Mike

Unregistered Supplier
ECF Veteran
Nov 29, 2013
626
1,322
Maui, Hawaii
www.vaporengine.com
The Xtar VP2 charger I picked up about a month ago showed information on the charging display panel when I first started charging, but sometime in the middle of charging my first battery, the display just went blank and no longer shows anything. When I returned to check on the status of my batteries, I could see nothing except the red/green LEDs for each battery.

It should look like this:
XTARVP2Display_large.jpg

but, instead, it stays completely blank.

The charger still works--after a while, the LED goes green and the battery reads fully charged on my Vamo--but I'm operating on pure guesswork for selecting the charging rate (shown in the center column on the display). Pressing the button above the display appears to still work (the time it takes to charge a given battery lengthens or shortens if I press the button in between charges); but I am not sure if the charge rate resets each time I unplug the charger, so I'm never exactly sure of what rate I am using.

The instructions for the charger are rather minimal, so I have been unable to figure out if there is a way to turn the display back on. Any thoughts?

I don't have it here but I've got no prob sending you another...then maybe you can send it to me and I can try to figure it out


Sent from my iPhone using Tapatalk
 
Status
Not open for further replies.

Users who are viewing this thread