Vector VV from Vapor Beast(Young June Version)

Status
Not open for further replies.

t8kiteasy

Ultra Member
ECF Veteran
Verified Member
Sep 22, 2012
2,690
1,980
59
virginia beach
Good morning everyone,I have an issue with the mod that has got me stumped at the moment.This might get lengthy to explain it,so please be patient with me.O.k.,the kit itself came with 2 3.0 ohm atty's,and 1 free carto(not sure of the cartos res. it was free).The first atty i used and started dripping for the first day,no problem at all,everythings fine.Go to bed and i took battery (2 18650 high drain batts not stacked) out and atty off,put everything in case.Next about 1-2 o'clock,grab for mod for a vape and put batt in,and atty on start dripping.About 1 hour later take a hit and nothing(got a reading of 9.9A,and a LO code on mod),unit is on and working nothing from atty.Put the second fresh atty on,nothing.So i took the first one that started working and grab my ego pop it on and it works fine.Second one,pop it on ego and it works too.Now go back to mod,nothing.I then took the free unused carto out and put it on mod it works???Again i try the atty's,nothing again,but they still do on ego???? I have 3 rba's i want to use on this mod but at this point i am not sure they will work either?? I am still waiting on tim to get back to me.The rba's work on the ego fine but i want to kick them up a little using the mod.Any advise,help,most appreciated.
 

t8kiteasy

Ultra Member
ECF Veteran
Verified Member
Sep 22, 2012
2,690
1,980
59
virginia beach
I got the smallest flathead screwdriver i have and tried getting the center pin back up but the connection is so narrow it is only moving the pin from side to side.I am not putting alot of force on it just nudging it because i do not want to break it.I finally broke down and made a fresh wick for the DID clone i have.I connected it and it fired,So just wanting to check again, i put the other 3.0ohm attys on to try.They still do not fire at all?I have the clone on right now and it is working perfectly.I have decided i am leaving well enough alone for the time being.Thanks for the reply.
 

Infinite

Senior Member
ECF Veteran
Verified Member
Jul 3, 2012
215
201
SF Bay Area, Sacramento CA
I got the smallest flathead screwdriver i have and tried getting the center pin back up but the connection is so narrow it is only moving the pin from side to side.I am not putting alot of force on it just nudging it because i do not want to break it.I finally broke down and made a fresh wick for the DID clone i have.I connected it and it fired,So just wanting to check again, i put the other 3.0ohm attys on to try.They still do not fire at all?I have the clone on right now and it is working perfectly.I have decided i am leaving well enough alone for the time being.Thanks for the reply.

Sorry for the late chime in. But it sounds like you are doing it right, u basically want to gently go from side to side with a jewelers flat-head. When u get one side raised ambit, work the other side effectively raising the entire pin. Depending on far recessed, it should take about 3-4 nudges. I hope that helps. As long as you are gentle, very little worry about damage.


Sent from my iPad using Tapatalk HD
 
Status
Not open for further replies.

Users who are viewing this thread