Vision HV Mini cleaning

[VaperEd]

Any suggestions or links on the cleaning procedure for the Vision HV Mini Extremes?
Help would be greatly appreciated [h=3][/h]

 

[eso]

Sure buddy,....after they stop glowing red with heat<-(this is important and may require the spit test),remove tip<-(I found it to complain the least turning counter-clockwise,although I did break 13 of the darn units before I done figgered it out),then take entire tank-unit to kitchen area<-(got directions from the wife on where it was located,I can ask her for you to if you wish),while holding tank unit with two fingers<-(I tried this with each of the other fingers too but each one finger couldn't hold it,took me awhile there too but your results may vary but two worked best for me)...

then hold the damned thing under running water and hope for the best...'cause I don't have a friggin' clue how to clean'em!

 

[VaperEd]

Apparently neither does anyone else

 

[burns_erin]

Disclaimer, I have some of these but haven't been afforded the opportunity to use them yet.

That being says, it looks like you'll have to take the metal ring the mouth piece screws into out first. And assuming these are pressed in and glued the same way the bases of visions are...the best way to do that is with heat. Like a baseboard heater or a blow drier. Heat up the tube and then gently wriggle it off. At that point you SHOULD be able to catch that plug seal with tweezers and pull it out.

I'm hoping this is the case...