Bought a Vision Spinner about a month ago and as of yesterday it won't hold a charge. Any ideas about what to do would be greatly appreciated.
Vision Spinner problem
- Thread starter Ern1953
- Start date
- th_trl_thread_readers 0
- Status
Maybe you need to lift the center pin back up? 
You can do that by using a very tiny screwdriver to gently (very gently) pry around that center pin, rotating as you go. Worth a try anyway, especially if you've been over tightening your tanks.
And welcome to the forum
You can do that by using a very tiny screwdriver to gently (very gently) pry around that center pin, rotating as you go. Worth a try anyway, especially if you've been over tightening your tanks.
And welcome to the forum
Check to make sure your threads and connections are clean before charging. If that doesn't help it has probably fizzled out on you. I replaced my spinner with the spinner 2 and had no problems at all with it. I have since went to a mod with replaceable batteries. I gave the spinner 2 to a friend that is still using it daily. Good luck.
So is it working at all?
Does it work but just not very long?
Does it turn on?
Vision 2's can be finicky, some of mine I had to disconnect and then reconnect for the dam thing to finish it's cycle. They are know for thinking they have completed the charge before they are actually done, mostly at the light change during charging.
Hope this might help.
Does it work but just not very long?
Does it turn on?
Vision 2's can be finicky, some of mine I had to disconnect and then reconnect for the dam thing to finish it's cycle. They are know for thinking they have completed the charge before they are actually done, mostly at the light change during charging.
Hope this might help.
I've owned two for a few months without any issues. Battery may be bad but a silly question, have you pushed the button 5 times since it might have been accidentally turned off?
- Status
Similar threads
