VVBox and VVpassthru

[TomCatt]

You got one of those headband magnifiers? Mine's on it's way from China. Ask CraigHB - hmmm, haven't seen him around lately - he uses those little bitty pieces I believe.

 

[TomCatt]

Idea ( probably a stoopid one ):

Cut a small piece of copper clad board (RS has this), scribe through the copper to separate three areas for the mosfet legs. Put a spot of solder on the copper where the legs will go, solder them on. Put a spot of solder on the copper of each area to solder wires to.

ETA: oops that white circle is supposed to be a mosfet leg


ETA: just looked at the datasheet for these - 3mm x 1mm

http://www.irf.com/product-info/datasheets/data/irlml6402pbf.pdf


Got any fairies down there BJ?

 

[BJ43]

ETA: just looked at the datasheet for these - 3mm x 1mm

Yea like all ten I bought fit on my finger tip.

The solder legs are smaller than one strand of my wire to the atty connecter.