What settings for Aspire Atlantis??

Status
Not open for further replies.

fulletank

Full Member
Nov 12, 2013
10
7
USA
I just got an aspire atlantis tank and an eleaf istick 30w. What voltage and wattage should I set my battery to considering it is a .5 ohm coil??? A general range would be nice. Also my battery is reading .9 ohms for some reason. Is there any special way to prime a tank like this or do I just do small puffs at first like any other tank?

Thanks :)
 

Kloverz158

Senior Member
ECF Veteran
Verified Member
Jan 10, 2015
136
32
ATL
To find the sweet spot just keep uping your watts until you are happy. And as for the istick reading not all coils will read 0.5 if you have a ohm meter and check your tank you will see that its not 0.5 on the dot at time its 0.58 in that case your mod will round it up but in your case its .4 higher so im not sure if you have the tank to screw on to tight or loose at time the 510 connector hate being stress out and thus making it read differently.
 

RamShot Rowdy

Battery Police
ECF Veteran
Verified Member
Nov 6, 2009
834
507
Oklahoma, USA
I run my Atlantis @ 30 watts with the airflow at maximum. Thats using an 80% VG juice with 6mg/ml nicotine. I can pretty much chain vape it at that setting w/o problems.

My shark says the coils are 0.6ish ohms.

Yes, you can NOT adjust both wattage and voltage at the same time, you set one, the computer figures out the other based on the resistance of the atomizer.
 
Status
Not open for further replies.

Users who are viewing this thread