I think ur collection hits it on the nail besides maybe the bb? by altsmkoke..any smaller 6v mods out there smaller than those Id like to see myself! Ill be following this thread closely, although Im a scaredycat when it comes to 6v using CR2s so I like bigger mods that hold a 18650/2 cr123s...
The smallest battery combination to get 6V is 2 CR2 batteries, so anything that will take two of those will be about the same size. It appears that the Little Gem is the smallest, but I don't think they're available at any of the US shops. Honestly, most 1 14500 / 2 CR2 mods will be close.
The Chameleon at 6v is 105.94mm. Just over 4in. Diameter is 19.04mm. Sits on top of a penny perfectly. Not sure of the size of the above mentioned mods.
With 14250 3v batts any 14500 device could be used on 6v. I didn't see those batts by myself, only read about them here (not sure they're protected yet). I'm about to order and check them on my Protege which has a chance to turn to very small 6v mod.
I'd say there's more information needed..like what atty are you looking to run at 6V..
reason I say this is that a low resistance 510 on a high-drain 16340 IMR will actually outperform a 4.5Ω atty at 6V..so would get you 6V+ performance in a much smaller device profile..like the chameleon (in it's small config)..
1.5Ω atty on highdrain 16340 3.7V battery =9.13W of heat
4.5Ω atty on stacked batteries for 6V =8W of heat
but it's dependant on the atty you want to run as well as the batteries..
I mean otherwise the super6 with it's unprotected CR2 is the smallest for stacked batteries
I'd say there's more information needed..like what atty are you looking to run at 6V..
reason I say this is that a low resistance 510 on a high-drain 16340 IMR will actually outperform a 4.5Ω atty at 6V..so would get you 6V+ performance in a much smaller device profile..like the chameleon (in it's small config)..
1.5Ω atty on highdrain 16340 3.7V battery =9.13W of heat
4.5Ω atty on stacked batteries for 6V =8W of heat
but it's dependant on the atty you want to run as well as the batteries..
I mean otherwise the super6 with it's unprotected CR2 is the smallest for stacked batteries
I'd say there's more information needed..like what atty are you looking to run at 6V..
reason I say this is that a low resistance 510 on a high-drain 16340 IMR will actually outperform a 4.5Ω atty at 6V..so would get you 6V+ performance in a much smaller device profile..like the chameleon (in it's small config)..
1.5Ω atty on highdrain 16340 3.7V battery =9.13W of heat
4.5Ω atty on stacked batteries for 6V =8W of heat
but it's dependant on the atty you want to run as well as the batteries..
I mean otherwise the super6 with it's unprotected CR2 is the smallest for stacked batteries
ok with cartos (I dont know the Ω rating on the 510 ones) the 808 cartos are a 3Ω which is gonna give you 12W of heat at 6V...
..but you're gonna have to use a stacked battery configuration...the smallest there is gonna be the stacked unprotected CR2..that smallest device is the Super6...
but if you want a device with protected batteries you're looking at something that can fit stacked CR123 size..and then for 6V you'd have the option of (2x) 3V LiFePo4 CR123 batteries
So you'd have to compare sizes of stuff that can run stacked CR123..I Think (but don't quote me on that) that the smallest for that configuration currently is the chameleon..
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.