When Ody rebuildable part stuck

[bacc.vap]

Sometimes when unscrewing the odysseus rebuildable part from GGTS base it will get stuck after a couple of turns, very stuck. I'm always able to get it unscrewed, but I was wondering exactly what caused this so maybe i could do something to prevent it. I'm wondering if maybe small silica fibers caught in the threads will cause it. I'm not sure what else it could be, does'nt seem likely that the oring would get stuck that tight or juice in the threads. Any ideas?

 

[RiverNut]

if I remember right, the oring CAN cause this. before you unscrew the rb part, loosen the inside nut a little from the bottom side pin. works like charm

 

[bacc.vap]

if I remember right, the oring CAN cause this. before you unscrew the rb part, loosen the inside nut a little from the bottom side pin. works like charm

Allright, thanks. I'll try that next time, and maybe try not to screw it in so tight to begin with.

 

[RiverNut]

a little lube with eliquid on the o-ring helps too

 

[imeothanasis]

the reason is that the nut that keeps the positive wire gets unscrewed too while you unscrew the rebuildable part bacc because of the o-ring under the nut that keeps the positive wire. The solution is to keep this o-ring lubricated