I have a Fuhattan mod, and I usually use the aspire Atlantis tank on it, but occasionally I switch to my turbo rda. Everytime I try to use my Atlantis after the turbo, it won't fire at all. I've tried a recharged battery, and a new coil, but nothing seems to be working. This has happened to me a couple times before, but after a couple of days my Atlantis starts working again... It's super annoying. Any ideas?
- Status
I had a similar problem is why I asked. One pin was a tad bit shorter than the other and it wasn't making a full connection. At least until I took the tank and battery out. Put on the tank then inserted the battery again. Sorry about your problem. I'm sure someone here can offer you a solution.
Tapped from my LG G3
Tapped from my LG G3
No, it seems pretty snug inside. I've tried adjusting the pegs and I'll get a hit occasionally, but it's not firing unless I really mess with the firing button
is the bottom button adjustable too? I have a Panzer that requires adjustment of the bottom tab on occasion, also had to change out the spring to a heavier thickness since the original one went limp.... some mechs have thin springs and when the button is pressed just "right" the current flows thru just the spring instead of a sleeve contact and unfortunately, the spring heats up goes soft and things quit working...
Mine just has a magnet and a negative pin the screws and unscrews. I constantly have to tighten it, because the magnet is very strong and pushes it away. I'm not sure that's the problem, I'm kind of afraid that maybe the tank I bought is just quiting on me early? I've had it for a few months now. Thank you for your help!
one other thing to look at then, ( do you have an ohm meter?) when it quits working, check the atty for ohms, sometimes the screws in the atty "loosen up" and quits working... the wire goes soft and no longer has a good connection in the atty, retighten the screws if this occurs.
- Status
Similar threads
- Locked
- Locked
