Which hardware shop and where?

[deathared]

But someone say 1/4" set screw collar sia. O: in the last time post.

 

[lictenau]

3/8" about 9.5mm collar am m5 screws. nearest fit. problem is the wing bolt. mcmaster has the most complete setup.

 

[Stinson]

yeah,must at least 9.5mm.The diameter of a carto is around 9.2mm so 5/16 too small.

 

[deathared]

Set Screw Collar: Stop Collar, Set Collar - Inch Dimensions | Ruland
I don't get it. Why does the inner diameter seem bigger than the bore. But when calculated its the same.
Or is it that the middle is say the outside is 5/8" - the bore 5/16" = 5/16x2 for the inner diameter? I'm so confused. Lol

[I was wrong, the guy said it's 5/16" for the inner diameter as well, he's nice enough to change to 11/16 for me! Bigger is better no? as long as it's not smaller!]

 

[Muramasa]

edit-wrong info

 

[deathared]

r3kka, but the usual diameter of a carto is 0.97cm leh. How to comfort fit if its too small.
Anyway for the one I just ordered, he said he'll replace to a bigger size. Cause the inner diameter he measured is 5/16". O:

 

[Muramasa]

edit wrong info 2

 

[deathared]

Can you measure your inner diameter and tell me? Maybe different brand that's why? Hmmm.

 

[Muramasa]

Hahahahha that just sounds weird.....
anyway i dun hv ruler at hm.. lol...
its 1.8ml length on a 12ml syringe with 0.2ml interval.
haha. when i get to a ruler then post again bah.

 

[surfer]

Let me get you a ruler.

iRuler.net - Online ruler

 

[Necromancer]

wah like tat also can hahahaa

 

[Muramasa]

lol jus checked. my carto puncher the bore is exactly 1cm.

 

[deathared]

Strange. But well, I got the bigger one, at least bigger can find screw in sg that are longer. So all's good!

 

[dvk]

Here is a good thread on punching cartos

Sources on where to get the saddle valve is in there too.

http://www.e-cigarette-forum.com/forum/general-e-smoking-discussion/231694-best-thing-ever-punch-cartos.html#post4353268