I just had something happen that I think everyone using whistle tips should be aware of - not sure if I had a defective odd ball or what. I was using my 5 volt PT with a HV 501 atty and a whistle tip. The HV does create more heat than the other attys but I usually let it cool between drips.
However, all at once when I took a drag and a plastic piece that was centered in the top of the whistle tip came loose and flew into my mouth. The piece was small enough that it could have gotten lodged in my lung. I assume that it was glued and the 2 weeks of use must have melted the glue letting it come apart. I bought this tip from a reputable supplier on this forum.
I just ordered some drip t-tips from NHaler so that I do not ever use these whistle tips again.
Anyone else out there concerned - wanted to give you a heads up. 8-o
However, all at once when I took a drag and a plastic piece that was centered in the top of the whistle tip came loose and flew into my mouth. The piece was small enough that it could have gotten lodged in my lung. I assume that it was glued and the 2 weeks of use must have melted the glue letting it come apart. I bought this tip from a reputable supplier on this forum.
I just ordered some drip t-tips from NHaler so that I do not ever use these whistle tips again.
Anyone else out there concerned - wanted to give you a heads up. 8-o