Who's to blame??

Status
Not open for further replies.

vapero

Ultra Member
ECF Veteran
Verified Member
Mar 13, 2013
2,830
3,566
monterrey,mexico
I've been vaping on my ego twist at 3.8 v and and evod 1.8 ohm for a few weeks, that was the right combination as if I passed the 4.0 mark everything started tasting burnt but a few days ago the forgot was becoming muted... today the flavor came back and saw that by mistake the volt disk was on 4.2 v ... So my question is ys my who dying out the evod could are about to give up (I clean and dry burn every couple of tanks)
Sent from my Galaxy Nexus using Tapatalk 2
 

vapero

Ultra Member
ECF Veteran
Verified Member
Mar 13, 2013
2,830
3,566
monterrey,mexico
I've changed a few heads and it's probably time. But as I pass the 4 mark this time the flavor seems great and not burned as I used to get before. That's why I think that somehow the ohms changed in a way (is it possible) I hope this will be the issue, if not then the battery is the problem

Sent from my Galaxy Nexus using Tapatalk 2
 

Whosback

Super Member
ECF Veteran
Mar 23, 2013
653
2,613
44
Pittsburgh, Pennsylvania, United States
The more you use a coil, the more gunk gets built up on it. Even normal cleaning won't get it totally free of gunk. This can cause the resistance to go up or down a little bit over the life of a coil. Just part of the natural life of a coil really. Should not be anything really wrong. Just means it might be time to recoil or get a new one.
 

warlike36

Ultra Member
ECF Veteran
Verified Member
Mar 13, 2010
2,142
652
54
Seymour,IN.
I've changed a few heads and it's probably time. But as I pass the 4 mark this time the flavor seems great and not burned as I used to get before. That's why I think that somehow the ohms changed in a way (is it possible) I hope this will be the issue, if not then the battery is the problem

Sent from my Galaxy Nexus using Tapatalk 2

Yes...Ohms can change and even be completely different than that of there label. If you have or can get a Meter you can test them.
 
Status
Not open for further replies.

Users who are viewing this thread