Sometimes I'll fill like 10 different clearomizers (the iclear 16s) and 2 out of the 10 will leak thru bottom it's so weird. Do any of you have this problem? I'll fill it up just like all the others I don't get it in middle pin...
Why do random ones leak?
- Thread starter EKat
- Start date
- th_trl_thread_readers 0
- Status
Inconcistency in the coil heads, is my guess. Or maybe some of them have bad O-rings.
Make sure the oring at the bottom is there and screwed on tight. If you're storing them with liquid take it out.
I occasionally have a coil head loosen while refilling.
Not sure what o ring is...when I twist bottom whole thing twists...
An o ring is a thin, white, almost transparent piece of rubber that seals the bottom of your clearomizer. Check the bottom of those that leak against those that doesn't leak, and look closely to see if there's anything missing. Take the head out too and check the connector and the base of the head. From where does it leak?
Under the wicks on the same shaft is a wide knurled part. Twisting that will remove the head. Look inside that you should see a white seal ( not sure it's an o ring ). That is what seals the head. I've never had to remove a head to stop a leak - just tighten a little. Over filling or getting fluid in the center hole can also cause leaking.
They look intact, there's also the or ing at top of mouthpiece and sometimes that comes off...
I just remembered a problem I used to have ( check automatically now ) the top cap above the coils must be aligned with the drip tip when you assemble it.
- Status
Similar threads
