hi everone i got my provari in yesterday and i have noticed that when i take a draw alot of times it cuts out and stopes vapeing for a second before resumeing . it happens with all my attys cartos/clearos ect. . the led light goes out and everything sometimes its more like 2 seconds . is this some type of safety feature?
why does my Provari cut out
- Thread starter rogue44status
- Start date
- th_trl_thread_readers 0
-
- Tags
- provari
- Status
What ohm resistance atomizer or carto are u using if its under 2 ohms set the provari to 4 volts.
havent figured out the issue yet it may be how im pressing the button but they ansewerd my email in like 3 min. at 2 am lol
well i have all diff ohm ratings . i have some from 1.5- 4.0 ohms and it happens on all and at all voltage ranges
no way forealz... lol jk yes i know hold down the button it happens while the button is depressed
This may or may not be your problem, but it happened to me.
The LED display and the actual internal button (along with the circuit board they are attached to) can move inside the body of the Provari if they weren't properly glued down. When this happens, the internal button can get out of line with the external button. You can see if they are lined up by looking through the external button at the internal button in bright light.
The LED display and the actual internal button (along with the circuit board they are attached to) can move inside the body of the Provari if they weren't properly glued down. When this happens, the internal button can get out of line with the external button. You can see if they are lined up by looking through the external button at the internal button in bright light.
I had this issue as well and realized it was becouse i was not firmly and fully depressing the button. I kept holding it at an angle.
- Status
