Wicking issue on Penelope v1

Status
Not open for further replies.

Aal_

Vaping Master
ECF Veteran
Verified Member
May 5, 2012
7,077
18,611
Toronto
OK, a few hours on. Tried the next setup. Two 2mm wicks on top kept very short. The lower one just in the channels for about 2mm, the rest empty.
Dry hits, JC up & down, good hits, JC up & down, good hits, dry hits, flooding.... D*mn. On to the next setup... :)

1- What watts are you running on, with what kind of wire?
2- Post pics
 

FogNL

Senior Member
ECF Veteran
Nov 25, 2013
218
189
Amsterdam
1- What watts are you running on, with what kind of wire?
2- Post pics

Thanks aalwani. I will post pics next time. This not complaining or anything. Just that I'm trying different setups on the PV2. The wire was plain silica from ESG. Coil 1.5 Ohm straight off the batt so around 9 Watts.

I have 3mm double on top in it now. Works OK(ish). Seems stable and predictable. The best performing setup I've had so far is 2mm silica in the channels down to the o-ring and double on top.
 

Bishopheals

Reviewer / Blogger
ECF Veteran
Verified Member
May 23, 2012
2,266
1,772
50
Staten Island
www.youtube.com
I just tried a 1.5 Ohm build with two 1mm wicks down the channels and a 2mm piece on top. Not recommended, dry hits all over the place. Even with the JC max'd out. :closedeyes:
Fog try my method in Video. If you do what I did it will give you great wetness, great moisture and heat. Like a train full of titties bouncing in your face.
 

Bigwhiterabbitt

Senior Member
ECF Veteran
Verified Member
Aug 7, 2013
98
68
N. Ireland
Fog try my method in Video. If you do what I did it will give you great wetness, great moisture and heat. Like a train full of titties bouncing in your face.

I like TiTTies... Sory to hear you've been unwell big guy, hope you're on the mend. Off to watch your vid now, been waiting on this.. lot of expectation here.. coz when I have my Penny set up right (sometimes takes a bit of tinkering) ..She Bangs!!!
 
Status
Not open for further replies.

Users who are viewing this thread