Wismec DNA200 battery recommendations?

[JMarca]

Hello! New here. I searched for an answer first, but I didn't find one.

I just got a Wismec dna 200. Now I need to get some good batteries

I will be using a Uwell Crown Ni200 0.15ohm coil between 50 and 100watts around 450 to 500F.

I was looking at the Sony VTC4's, but I wanted to see if that would be a good pick or not for the coil and watts

I got AWT 18650 3000mah 3.7v 40A for it just to get vaping, but I know these are not very good.

Any good suggestions?

Thanks in advance!

At your vape preference I would really recommend the Sony VTC4. You're going to want to make sure you have the proper settings for your batteries in escribe, especially important for the Wismec DNA200 (or any DNA 200 device really) since not all 18650s are created equal. Your battery discharge profile and your watt-hour settings are not automatically updated.

-----------------------------

Here is a tutorial that's specific to YOUR device:

Download and Install Escribe

Take the mod and plug it in to the PC, wait for everything to download from the device...

Go to the Mod tab, click on watt-hour calculator, it will ask if you know the total voltage say yes.
Battery cell Capacity type in 2100 (change this to the proper mah rating for YOUR battery if you get anything other than a VTC4), nominal voltage should be 11.1v

Next you will download the csv file from this post (see below)

After you download the csv file go in escribe: Load CSV > <wherever you put the CSV file you downloaded>

Now your mod understands your batteries alot better and the meter makes more sense.

At this point click on File > Save > and save it wherever you want keep this file in a safe location. This is your settings file backup.

After this you pretty much can mess around with themes, profiles, etc...
Make sure you have a good backup first with a battery discharge profile that matches your batteries.

If you have any questions reply or send me a PM.