Wondering about my new build..

[this is cheese]

New cotton single coil build I wrapped on my Nimbus XL clone with twisted 28 gauge kanthal, sitting on top of my k100 mech.
I was wondering what yall thought of it, cause it's my third build. It reads .6 ohms and vapes great...

Question is, I can't seem to fit another coil in because the holes on the posts aren't big enough, any of yall have a solution for that? Thanks in advance

 

[State O' Flux]

It reads six ohms and vapes great...

Question is, I can't seem to fit another coil in because the holes on the posts aren't big enough, any of yall have a solution for that? Thanks in advance

Looks good enough, but... 6 ohms!?!?! Unless there's something I'm missing, I think you've not measured that correctly. 0.6Ω maybe... but not 6.0Ω.

Drill out the post holes.

 

[this is cheese]

Looks good enough, but... 6 ohms!?!?! Unless there's something I'm missing, I think you've not measured that correctly. 0.6Ω maybe... but not 6.0Ω.

Drill out the post holes.

Whoopsie dasies! I meant .6 ohms I'll fix that, thank you for the reply

 

[State O' Flux]

Whoopsie dasies! I meant .6 ohms I'll fix that, thank you for the reply

Well... at least my old geezer eyes still work well enough. Now, if only the rest of me did. ;-)

 

[Thepmc81]

No need 2 drill out the post holes!! Just wrap ur kanth leg around under the post screw & tight'n it down as u wld with an rda without post holes


Sent from my iPhone using Tapatalk

 

[BuzzKilla]

use one wire....

wrap the second coil using the lead from the first one.
It may be a bit tricky, but it is the easiest way to go without modifying your atty.

but the easiest way is to ditch the twisted wire.
That way you don't go into crazy low ohms, and you can build your coils the easy way.