World Exclusive SmartVapes Dripping Atomizer Custom Built for Dripping

Status
Not open for further replies.

ukeman

PV Masher
Supporting Member
ECF Veteran
Verified Member
Aug 22, 2010
7,718
5,129
Kauai, Hawaii
I've just put one of my LR 510 dripping attys on and have to say that it is much more satisfying than a couple of highly recommended attys from another vendor that have come out lately and at higher prices...
I don't have leaking issues.
Good thing i have a stash of all kinds of "dripping attys"... i got a bunch and i am so glad i did....

If this post sounds corny .... hmmm maybe it's because it's true?
 

ukeman

PV Masher
Supporting Member
ECF Veteran
Verified Member
Aug 22, 2010
7,718
5,129
Kauai, Hawaii
I just loaded a fresh LR 1.8 510 on my VV... anywhere from 3.5 to 4.0v... 2 days so far ( i used the last one a couple of weeks and still working but i don't like the taste after a couple weeks.. typical of most attys). .. no leaks, tons of vapor and taste. The only thing about em is the draw is slightly airy.
On average, very good atty imo.

I never overfeed... 3 to 4 drops ... redrip every 5 or 6 vapes; it is a bit of a hog, but consistent good vapes; can't just put it down... i've got 306's to try (1.5 Ohm) and 901's too.
 

wolcen

Ultra Member
ECF Veteran
Verified Member
Mar 9, 2011
1,182
1,302
Boston, MA
www.wolcen.com
I'm sorry to say that these things were just terrible. Leaky as all get out, and BOTH died in less than a week when used on a device they're meant to be on. Can't say I'll ever purchase again, kinda feels like a giant waste of money, considering I have attys that have lasted four months or more. Sadface.

Well, the leakiness happens with these with anything but very-thick liquid IMO (I've used VG-only that was on the thin side and it leaked), but I'm surprised to hear about the lifetime. I've used the same one @ ~3.7v for over two months with no loss in performance. Unlike some, I DO dry burn atties, even at a slightly elevated voltage, to get them simmering orange across the coil again and it works great for me. I've only felt I've had to dry burn these twice so far I think.
 

ukeman

PV Masher
Supporting Member
ECF Veteran
Verified Member
Aug 22, 2010
7,718
5,129
Kauai, Hawaii
I just tried one of my blue tipped LR 306 dripping atty; i use a VV at low voltages.
This is better than the 510 in draw imo... a little more resistance; not a lot, but my only complaint about the 510 is the draw is airy...
It's a juice hog, both are; but that's because there's so much vapor!
 

Dalton63841

Moved On
Feb 14, 2011
3,456
3,214
41
Maine
I just got a 5-pack of the 3ohm Dripping Atomizers in the mail today. I put one on my Provari, dialed it in to 5.6v, put 3 drips in and waited a minute, then 3 more drips...

Long story short, they were great right from the start, but after about half a day of vaping, this thing is like a smokestack! Very glad I went for the 5-pack, and will definitely order again.
 

MrAftrmth

Super Member
ECF Veteran
Verified Member
Nov 19, 2011
524
522
LosAngeles
How is it on the provari after a couple of days? Thinking of getting one myself.

I just got a 5-pack of the 3ohm Dripping Atomizers in the mail today. I put one on my Provari, dialed it in to 5.6v, put 3 drips in and waited a minute, then 3 more drips...

Long story short, they were great right from the start, but after about half a day of vaping, this thing is like a smokestack! Very glad I went for the 5-pack, and will definitely order again.
 
Status
Not open for further replies.

Users who are viewing this thread