Wotofo Faris RDA/RDTA

[Dr. Seuss]

Is it unheard of for a postless deck to have the holes drilled unevenly? I’ve tried multiple times to get this thing balanced and it is a new level of pia. They even give you a little bent piece of metal as a gauge to clip your coils so I don’t know how these are seated and yet one is always higher than the other. Try and reseat, they’re bottomed out.

I just can’t figure out how I’m messing this up. The only new factor here is this postless deck faris.

 

[Dr. Seuss]

I know man, I know. Just screaming “user error” man. Ya’ll don’t even need to say it.

Turns out one of the screws was jacked about 2/3 the way down the threading so it was misleading a brother into thinking it was seating down snuggly when in reality it wasn’t. If a person were to get so frustrated as to crank that screw they would find it “turned through” about another half rotation or so.

I pulled out one of the replacement screws sent, looked it over, screwed it in and as reason would have it everything worked out just like you would think it should.

Mind your screws folks.

 

[Dudeman]

"Made in China"