I just received my Zmax from madvapes where I also ordered five 3.2 ohm cartomizers. I vaped through two cartos and then I filled the carto and the tank and screwed it on. When I went to take a drag nothing happened. I looked at the screen and it says "0.3o" and so I screwed on different cartos and attys and they all fire without flaw. So I take out the terrible little guide they give you and look at the error codes and all there is, is "LOU" Low Voltage Indication and "LOR" Low Resistance Indication. It sucks because I just filled it with juice and filled the 6ml tank so I dont want to lose all this juice. Has this happened to anyone else and do you know a fix for this problem? Also does anyone know what the "0.3o" is?
- Status
I have also had the problem of my Zmax continuing to fire until it burns out my carto or atty, or if i unscrew the carto/atty or take out the battery it will stop.
Try taking a small screw driver and pulling the pin out slightly on the carto. Could be the pin isn't making good contact. If that doesn't work then you probably got a bad carto. If you have a syringe you can get the juice out of the tank and fill another carto and put in the tank.
Well hope everything looks up for you. Take Bluesnakes advice and move on. Bad cartos and attys will happen from time to time
Water of a ducks bacK
Water of a ducks bacK
The 0.3o is an ohms reading. The cartomizer is under the limit for ohms that the Zmax will accept. The cut off is 1.2 i think, but the Zmax can cut off a bit higher than that. Sounds like you have a dud cartomizer. If the other cartomizers and attys fire ok then that one is a dud - possibly not coiled properly or has popped a coil.
On the firing - it shouldn't keep firing. There is a ten second cut of time if it does misfire. If yours keeps firing like that then open a ticket with Mad Vapes.
- Status
Similar threads
