Just cleaned my 510 atty after a week of heavy use and a...well let's say less than usefull mod. http://www.e-cigarette-forum.com/forum/cartridge-mods/105116-zippo-wick-does-trick.html
I used the crest Pro Health methode. Just put an atty in a small vile, covered it w/ The mouthwash and shook vigorously for a min or so. Let it sit @20 min, then rinsed well w/ hot water. I then blew it out, both sides, by mouth(mouth on the batt end, lips an inch away on the cart end). Gave it a dry burn, then a water rinse w/ a dropper, blew dry again then another dry burn. At this point it lit up perfectly, so I primed it w/ a little Juicy Peach, tailgated it for a couple of light puffs, then put on a full cart(tea bag, but not the PTB). Works better than new.
Oh, BTW. I believe the problem we had may be different(I had a bad burnt taste), but the cause may be similar. I believe the fiberglass strands in the atty get gunked up and can't feed the coil fluid from the bridge properly.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.