Battery Charge on Double Parallel unregulated box

Status
Not open for further replies.

kerby82mex

Full Member
Jan 28, 2016
11
4
41
I'm using and 2 parallel battery unregulated box.

At the moment I'm charging the battery when they reach 3.6v, I'm using a volt meter to know when that voltage is reached.

Since when I change the battery I still can vape good, I was wondering if since the batteries are parallel I can go below 3.6v.

I usually don't vape below 0.5 ohm.

Any suggestion?
 

suprtrkr

ECF Guru
ECF Veteran
Verified Member
Jun 22, 2014
10,410
15,046
Cowtown, USA. Where the West begins.
Do not take a lithium chemistry battery below 3.2 volts, this damages them. Given you are using a mech mod, and still find the vape satisfactory at 3.6V, there is no reason you can't vape it down a bit lower if you like. Having said that, be aware charging before the minimum extends the life of your batteries. Most of them are good for +/- 300 cycles. However, that's 300 1-volt cycles, the difference between 3.2 and 4.2 at full charge. If you charge at 3.6, that's only a half-volt cycle and you should get approximately twice as many in the battery useful life.
 
  • Like
Reactions: IMFire3605
Status
Not open for further replies.

Users who are viewing this thread