I am in for AT LEAST one for sure right out of the gates!
These are a few custom tips that went up on the site recently! We have more unique one of a kind tips by Jason going up this week!
Sent from my Minds Eye
Did they sell already?
I couldn't find them.
Both of these are really nice pieces. May I give a tiny bit of advice? When you're doing attachments like in the first picture, it's absolutely critical to the strength of the entire piece to make sure that when you join the subject and the attacment, both surfaces should be 3rd red, or white hot and soupy. I can tell on the bottom two attachments the body of work wasn't hot enough and they were melted in after the fact. Also not quite enough by the looks of the one on the bottom right.
Please don't think I'm talking down to you or your flame worker friend. I'm not; the work is gorgeous. I'm just sharing what I've learned over the past 12 years as a hot glass artist (flameworker) to save some heart break. I've had quite a few pieces break catastrophically with 10+ hours in them. To the point that I have to trash it. I hate it and even more so, hate to see it happen to other artists.
Take this octopus for example. This is version 2 after the first one broke beyond repair due to a 1mm long section not melted in all the way. It had over 12 hours of work in to it, not including probably 20 hours in the kiln. Notice how the tentacles and the body look to be one single piece.
If I would have taken the time and made sure that my welds were good I'd have saved myself 2 days of work and several thousands of dollars of labor.
Again, please don't think i'm saying your DTs are't nice. They very much are!!!!
On another note I just bought a honey pot and peanut, both Steel House from your site! I freaking LOVE Disco Sparkle/Steel Wool. Try mixing it 1 part steel wool to 5-10 part of almost any color. Especially WYSIWYG (What you see is what you get) colors, cadmium/crayon colors aside. Or mix it up with itself, pull back in to a rod and coat it with a transparent color. Instant bling. Cobalt is great if you thin it a bit before striping it on DS/SW. Also amber/purple.
Interesting Shat! What type of atomizer is it?? I haven't had that problem! The base of your specific tip may have been cut a hair too short causing the top o ring to expand at the base of the tip! I'd be happy to send you another if that is the case!
Sent from my Minds Eye
These are a few custom tips that went up on the site recently! We have more unique one of a kind tips by Jason going up this week!
Sent from my Minds Eye
Smart vape 510. Maybe House of Vapor's Stingray 510.
Those are both gorgeous! They Wysteria, Aqua and Star White color way is breathtaking.
Can I commission a custom tip like the one on top with the Shamrock, GA Mint, Acid Yellow Crayon and Dichro?
I'm sure we could work something out
Sent from my Minds Eye
Hi rabernet,
Try looking here: Envision Vapor - Blog | Envision Vapor
All the shapes are labeled on the blog page.
Hi Rabernet,
If you select a color pattern and then select the different shape in the drip down menu a picture of that shape will pop up. Not all color patterns are updated but most of them are Thank you. Hope this helps!