Not sure if they all of a sudden came back into stock but I remember not being able to find dna boards. TheHouseOfVapor.com appears to have DNA30D boards in stock for $49.99. I figured I would give everybody a heads up just in case.
Heads up on DNA30D
- Thread starter militiascene
- Start date
- th_trl_thread_readers 0
- Status
Thanks. But too late for me - after months of searching for the DNA30D, I finally decided to go with a SX350 board for my next mod.
I'm in the same boat with DrMA. I held out for the DNA30 but there was no ETA on that so I too went with the sx350. So far I'm very pleased with the testing of the sx350. Almost done with the build, can't wait to light that baby up!
I am hoping someone can help me with the Poly Switch selection and installation. I am in the process of building a DNA20 a separate DNA30 mods and I also have a SX350 on hand.
I came across one of mamu's post and manu stated that for DNA30 use 2 MINISMDC260F/16 poly switch in parallel and 1 MINISMDC260F/16 for DNA20 to protect from battery polarity reversal.
But the Amperage hold is 3.0 and Amperage trip is 6.2. Since the max amperage is 12.5, don't I need at least three MINISMDC260F/16 poly wired in parallel? Can someone help me with this topic? Thanks!
I came across one of mamu's post and manu stated that for DNA30 use 2 MINISMDC260F/16 poly switch in parallel and 1 MINISMDC260F/16 for DNA20 to protect from battery polarity reversal.
But the Amperage hold is 3.0 and Amperage trip is 6.2. Since the max amperage is 12.5, don't I need at least three MINISMDC260F/16 poly wired in parallel? Can someone help me with this topic? Thanks!
Last edited:
- Status
Similar threads
